5. Insufficient pressure:
The compression ratio of the mold is small, the pressure is insufficient, the finished pellets will be too loose, the bonding force is insufficient, and they will break into powder at a touch. Increasing the compression ratio of the pellet machine mold can solve this problem.
6. Wear of the seal ring:
If the seal ring is damaged, the raw material dust will leak from the hole in the bearing chamber. Over time, a large amount of dust will enter the main shaft bearing chamber, and the bearing will be easily damaged. Therefore, after using it for a period of time, be sure to check the seal ring, and replace it if it is worn and deformed. Remember to remove the mold when replacing it.
In short, choose the right pellet machine equipment, learn more about the pellet machine, do a good job of maintenance, and use JNSHARE's high-quality mold rollers. These wear-resistant accessories can extend the service life of the equipment, reduce costs, and improve production efficiency!
If you want to know more about our pellet machine, welcome to subscribe to our YouTube channel.